Creating your Project

Bounding box around the project creation wizard in Tuner X
  1. Wheel Radius (inches)

    • The radius can be found by measuring the width of the module wheel, then dividing that by 2.

  2. FL to FR distance (inches)

    • This is the distance between the center of the front-left module, and the center of the front-right module.

  3. FL to BL distance (inches)

    • This is the distance between the center of the front-left module, and the center of the back-right module.

  4. Module Type

    • The type of swerve module, such as WCP Swerve X standard, flipped gear, or flipped belt. Users not using any of the supported modules should select Custom instead.

  5. Drive Ratio

    • This is the gearing ratio between the output shaft of the motor and the module wheel. Swerve X users can find that information here.

  • Steer Ratio (Custom)

    • This is the gearing ratio between the output shaft of the steering motor and the azimuth gear. For the Custom module type, users must calculate this based on their gearing themselves, or consult their manufacturer.

  1. Import Project

    • Import an existing Tuner X swerve project save file.

  2. New Project

    • Create a new project based on the settings configured.

Users should configure the settings applicable for their robot and click New Project once they are done.

Tip

Throughout the application is various tooltips, that when you hover on them, provide instructions. If you are unsure on what something means, try hovering on it!

Wizard Options

Once a project is open, a couple of options are exposed at the top-right.

Picture of the factory default, config, exit project, and save project options.

In order from left to right:

  • Factory default all devices

  • Open the swerve settings menu

  • Export project

  • Exit project